Folks,
I have aquired a 3620 (second hand), and have upgraded the IOS from
c3620-i-mz.120-7.XK1.bin to
c3620-is-mz.121-5.T9.bin
Since the upgrade, everytime I boot up I get this message;
Self decompressing the image : #### ...
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
0000D7 0X00128810 Fast Ethernet Combo Port Module, 2 WAN
00002A 0X000D5000 One port Channelized E1 (120 Ohm - TP)
0X0010A6F8 public buffer pools
0X00211000 public particle pools
TOTAL: 0X00518F08
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 6Mb.
Using 9 percent iomem. [6Mb/64Mb]
When I go back to the original image (12.0) it boots up fine with no error
messages.
I am running the 12.1(5) image on another 3620 that is identical this router
with no problems.
Can someone point me in the right direction or give me some URL's regarding
this problem
Thanks
Chris
-------------------------------
Full boot up sequence;
00:01:38: %SYS-5-RELOAD: Reload requested
System Bootstrap, Version 11.1(17)AA, EARLY DEPLOYMENT RELEASE SOFTWARE
(fc2)
Copyright (c) 1998 by cisco Systems, Inc.
C3600 processor with 65536 Kbytes of main memory
Main memory is configured to 32 bit mode with parity disabled
program load complete, entry point: 0x80008000, size: 0xa197d8
Self decompressing the image :
#################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
########## [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
0000D7 0X00128810 Fast Ethernet Combo Port Module, 2 WAN
00002A 0X000D5000 One port Channelized E1 (120 Ohm - TP)
0X0010A6F8 public buffer pools
0X00211000 public particle pools
TOTAL: 0X00518F08
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 6Mb.
Using 9 percent iomem. [6Mb/64Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-IS-M), Version 12.1(5)T9, RELEASE SOFTWARE
(fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Sat 23-Jun-01 21:35 by cmong
Image text-base: 0x60008950, data-base: 0x61130000
cisco 3620 (R4700) processor (revision 0x81) with 59392K/6144K bytes of
memory.
Processor board ID 07659611
R4700 CPU at 80Mhz, Implementation 33, Rev 1.0
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
1 Channelized E1/PRI port(s)
DRAM configuration is 32 bits wide with parity disabled.
29K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: n
Press RETURN to get started!
00:00:21: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
00:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0,
chang
ed state to down
00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0,
chang
ed state to up
00:00:31: %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to
administr
atively down
00:00:31: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-IS-M), Version 12.1(5)T9, RELEASE SOFTWARE
(fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Sat 23-Jun-01 21:35 by cmong
00:00:32: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0,
chang
ed state to down
Router>
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:24 EDT