[nsp] RTO in rotary-group

From: Rakesh (rakesh.menon@tataisp.com)
Date: Wed Apr 03 2002 - 07:40:13 EST


Hi ,

Have created a setup where i have created a dialer interface with 2 BRI interfaces in it. This has been done using rotary-group cmd in each bri interface. So both the BRIs dial onto the 3com RAS . But observing that incase 1 bri line goes down , getting continuous request time outs even though the other line is up and connected . On the line coming up ie back onto 2 bri lines(4 channels) , then ping becomes normal after 2-3 min. Ideally after some 2-3 RTO's it should become normal. The default route in that router is towards the dialer. No other route exists. Could anyone help me out why this could be happening.

Thx&Rgds
Rakesh
 





This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:39 EDT