RE: [nsp] OC3 POS interface.

• Next message: Miguel A.L. Paraz: "[nsp] HSSI or Octal Cable extenders?"
• Previous message: chester@corp.thrunet.com: "RE: [nsp] 12008 problems sending packets?"
• Maybe in reply to: shiva: "[nsp] OC3 POS interface."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Are the resets occuring at about the interval of the
keepalive (default 10 sec.)? If so, line protocol is
never really coming up. Look for a physical problem,
most often a bad fiber connector or cable.

-----Original Message-----
From: shiva [mailto:shiva@iasiaworks.com]
Sent: Sunday, August 13, 2000 9:17 PM
To: cisco-nsp@puck.nether.net
Subject: [nsp] OC3 POS interface.

Hi List,
 
I have an OC3 hooked up to a 7206VXR on either end, both the ends are free
of any alarms(they even show up/up on both ends). But the interface keeps
resetting itself periodically with resultant line protocol going up and
down. HDLC is the default encap, framing is sonet, and have tried all timing
combinations. I am troubleshooting this end-to-end with the carrier.
Meanwhile any ideas/suggestions on this?
 
Thanks in advance.
shiva balasubramanian
senior network engineer
iasiaworks

• Next message: Miguel A.L. Paraz: "[nsp] HSSI or Octal Cable extenders?"
• Previous message: chester@corp.thrunet.com: "RE: [nsp] 12008 problems sending packets?"
• Maybe in reply to: shiva: "[nsp] OC3 POS interface."
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:15 EDT