Tried ip route 216.223.201.0 255.255.255.248 Serial5/1/11:0 ??
is ip subnet zero in place??
Brian "Sonic" Whalen
Success = Preparation + Opportunity
On Wed, 8 Aug 2001, Charles Sprickman wrote:
> Hi,
>
> I'm turning up a new t1 customer that is connected via a CT3 interface.
> On adding a static route, I get the following message:
>
> core-1(config)#ip route 216.223.201.0 255.255.255.248 216.223.200.66
> %Invalid next hop address (it's this router)
>
> It seems to be lying.
>
> The interface has the next address down in the .64/30:
>
> Serial5/1/11:0 is up, line protocol is up
> Hardware is PA-MC-2T3+
> Description: -circid-
> Internet address is 216.223.200.65/30
>
> The routing table entry for this looks correct:
>
> core-1#sh ip route 216.223.200.64
> Routing entry for 216.223.200.64/30
> Known via "connected", distance 0, metric 0 (connected, via interface)
> Redistributing via ospf 1
> Advertised by ospf 1 subnets
> Routing Descriptor Blocks:
> * directly connected, via Serial5/1/11:0
> Route metric is 0, traffic share count is 1
>
> Looking for something else with the .66 address in the running config is
> futile:
>
> core-1#sh conf | inc 216.223.200.66
> core-1#sh conf | inc 216.223.200.65
> ip address 216.223.200.65 255.255.255.252
>
> This is a 7206 VXR running 12.0(7)XE1 with CEF enabled. Turning CEF
> on/off or on/off/on has no effect.
>
> The T1 also shows up/up (hdlc), and has tested clean to the smart jack,
> but I cannot ping the far end, likely because it seems the router thinks
> it has an interface somewhere with that address. At some point in the
> past I had a PA-T3 in the chassis that had that address, but the card has
> been removed AND the router has been reloaded afterwards.
>
> Where else can I go with this?
>
> Thanks,
>
> Charles
>
> | Charles Sprickman | Internet Channel
> | INCH System Administration Team | (212)243-5200
> | spork@inch.com | access@inch.com
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:48 EDT