[nsp] How Keepalive works ? ? ? ? ?

• Next message: Chris: "[nsp] etherchannel on Cat65"
• Previous message: Gert Doering: "Re: [nsp] Cisco 7204 VXR Fast Ethernet lock up after reconfiguration"
• Next in thread: Tejal Shah: "[nsp] How Keepalive works ? ? ? ? ?"
• Maybe reply: Tejal Shah: "[nsp] How Keepalive works ? ? ? ? ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hi all,

   I want to implement keep alive on my virtual templante
and enabled vpdn on my ubr7246VXR.

   I m confused abt how much packet did my router send to
client and how i configure it for retry for 2 times, if
client didn't respond after 2 retry then that vpdn session
should get disconnect.

Following is the configuration......
=============================================
interface Virtual-Template1
 mtu 1492
 ip unnumbered Cable3/0.2
 ip access-group telnetfilter in
 ip mask-reply
 ip accounting output-packets
 ip accounting access-violations
 no ip route-cache
 keepalive 600
 peer default ip address pool abcd
 ppp authentication pap callin one-time

==============================================

Thanks in advance

Tejal
 ppp timeout ncp 30
 ppp timeout authentication 20

Go To http://www.iqara.net

• Next message: Chris: "[nsp] etherchannel on Cat65"
• Previous message: Gert Doering: "Re: [nsp] Cisco 7204 VXR Fast Ethernet lock up after reconfiguration"
• Next in thread: Tejal Shah: "[nsp] How Keepalive works ? ? ? ? ?"
• Maybe reply: Tejal Shah: "[nsp] How Keepalive works ? ? ? ? ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:59 EDT