[nsp] to tell WIC-2T from WIC-2A/S

[Scott.Keoseyan@BroadWing.com]

try 'show diag'


        WIC Slot 0:
  !---->Serial 2T (12in1) WAN daughter card
        Hardware revision 1.0           Board revision B0
        Serial number     14845267      Part number    800-03181-01
        Test history      0x0           RMA number     00-00-00
        Connector type    PCI
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 12 01 00 00 E2 85 53 50 0C 6D 01 00 00 00 00
          0x30: 58 00 00 00 99 06 30 00 FF FF FF FF FF FF FF FF



> -----Original Message-----
> From: Victor Sudakov [mailto:sudakov@sibptus.tomsk.ru]
> Sent: Friday, September 20, 2002 10:00 AM
> To: cisco-nsp@puck.nether.net
> Subject: [nsp] to tell WIC-2T from WIC-2A/S
> 
> 
> Colleagues,
> 
> There are a WIC-2T and a WIC-2A/S modules in a c2610. Their interfaces
> are visible as Serial0/0 to Serial0/3. Is there a way to tell whether
> a particular interface belongs to a WIC-2T card or to a WIC-2A/S card?
> The "show controller" output for all the four interfaces seems
> identical.
> 
> Thanks a lot for any input.
> 
> -- 
> Victor Sudakov,  VAS4-RIPE, VAS47-RIPN
> _______________________________________________
> cisco-nsp mailing list  real_name)s@puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 
 +++The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material.  Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited.   If you received
this in error, please contact the sender and destroy any copies of this
document.+++