[nsp] 6503 + FlexWan problem?

[Simon Lockhart]

Hi,

I've got a 6503 which we're trying to install a FlexWAN module into.
However, whenever we insert the FlexWAN into the chassis, it powers down,
and won't power on again. Remove the flexwan, and it powers up.

We've tried two flexwan's, so we're fairly sure it's not that. We've
tried a diffrent card in the same slot, and it works fine.

My instant response was that there wasn't enough power available, but
that seems fine:

rt0.ash#sh power
system power redundancy mode = redundant
system power total = 21.890A
system power used = 8.350A
system power available = 13.540A
FRU-type       #    current   admin state oper
power-supply   1    21.890A   on          on
module         1    2.830A    on          on
module         2    2.830A    -           -   (reserved)
module         3    2.690A    on          on

Has anyone else seen this before? Any suggestions?

The other cards are:

Mod Ports Card Type                              Model              
--- ----- -------------------------------------- ------------------ 
  1    2  Cat 6k sup 1 Enhanced QoS (Active)     WS-X6K-SUP1A-2GE   
  3   48  48 port 10/100 mb RJ-45 ethernet       WS-X6248-RJ-45     

Simon
-- 
Simon Lockhart     |   Tel: +44 (0)1628 407720 (x(01)37720) | Si fractum 
Technology Manager |   Fax: +44 (0)1628 407701 (x(01)37701) | non sit, noli 
BBC Internet Ops   | Email: Simon.Lockhart at bbc.co.uk        | id reficere
BBC Technology, Maiden House, Vanwall Road, Maidenhead. SL6 4UB. UK