[nsp] anyone ever lost all their T-1 WICs at once?

[Chris Hale]

Rebooted several times.  I debugged the serial interface, with no errors.
The service-module T-1 shows no T-1 errors at all.  The Ethernet interfaces
are fine and pass traffic without issue.

No config changes had been made for over two weeks, and the 5 T-1s had been
running fine for almost two months.

Chris

----------------------------------------------
Chris Hale
Peak Networks, Inc.
http://www.peaknetworks.com
800-PEAK-987
chris at peaknetworks.com
Motorola ACSP, Alvarion AIR, Certified Orthogon, Redline, Cisco, Terabeam
Partners.

 
 


-----Original Message-----
From: Robert Boyle [mailto:robert at tellurian.com] 
Sent: Saturday, May 22, 2004 10:32 PM
To: Chris Hale
Cc: cisco-nsp at puck.nether.net
Subject: Re: [nsp] anyone ever lost all their T-1 WICs at once?

At 10:22 PM 5/22/2004, you wrote:
>Anyone ever had this happen before?  It's obviously an issue with the T-1
>WICs, but why did we lose all 5??  Is there an issue with only the WICs
>(i.e. I get 5 new ones and we'll be good), or do I need new network
modules,
>or even a new 3640?
>
>How do I prevent this from happening again?

Dumb question, but did you try to power cycle the router to see if that 
clears the errors? It sounds more like a software bug or maybe hardware 
power supply failure than a one in a trillion failure event. Does the 
router's error log say anything about the WICs?

R


Tellurian Networks - The Ultimate Internet Connection
http://www.tellurian.com | 888-TELLURIAN | 973-300-9211
"Good will, like a good name, is got by many actions, and lost by one." - 
Francis Jeffrey