[c-nsp] load-balance over multiple E1

[Amol Sapkal]

Prit,

Do you have cef enabled?

> ip route 1.2.3.0 255.255.255.0 serial1
> ip route 1.2.3.0 255.255.255.0 serial0
> 

I dont see any reason why your router is not showing 2 routes for the
network. You sure the other interface was not down?

> but when i see routing table for network 1.2.3.0 at that time only one
> e1 is getting used for this network.

How do you say only one interface was being utilized?


On Wed, 6 Oct 2004 10:06:38 +0530, Prit Patel <shahtejal at gmail.com> wrote:
> Hello All,
> 
> How can we do per packet load-balance on multiple E1 with same
> capacity connected to same provider.
> 
> I have 2 E1 connected to same provider and running BGP on loopback.
> I want to do eqal load-balance on both the link.
> 
> I have added two static route for a network e.g.
> 
> ip route 1.2.3.0 255.255.255.0 serial1
> ip route 1.2.3.0 255.255.255.0 serial0
> 
> but when i see routing table for network 1.2.3.0 at that time only one
> e1 is getting used for this network.
> 
> pl help me out.
> 
> Regards
> Prit
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 


-- 
Warm Regds,

Amol Sapkal

--------------------------------------------------------------------
An eye for an eye makes the whole world blind 
- Mahatma Gandhi
--------------------------------------------------------------------