[c-nsp] How to apply an access-list to all the sub-interfaces

[Mario Antonio]

In the following configuration (Router 2621XM), Can I apply an access-list
to the interface  f0/1, so the subinterfaces will inherit that access-list?
Or the only way is to apply to every single sub-interface?

==> I want to filter traffic among these sub-interfaces--

Regards

Mario Antonio

======================

!
interface FastEthernet0/1
 no ip address
 ip access-group 130 in
 speed 100
 full-duplex
 no cdp enable
!
interface FastEthernet0/1.1
 encapsulation dot1Q 300
 ip address 10.20.100.1 255.255.255.0
 no cdp enable
!
interface FastEthernet0/1.2
 encapsulation dot1Q 201
 ip address 10.20.200.1 255.255.255.252
 no cdp enable
!


Regards

Mario Antonio

---
[This e-mail was scanned for viruses by Webjogger's AntiVirus Protection System]