[c-nsp] bridging continued

[Scott Granados]

Hi, so I h ave set up the following with no success, what did I miss.

Router A. has a fast E attached to the 10.0.1.x ip space at 10.0.1.254,
It's serial interface is 10.0.1.252 

Router b. is 10.0.1.253 and it's serial is  10.0.1.251 all in a /24 mask.

Router b also has a second Ethernet of 192.168.1.0/24 

Serials on both routers have bridge-group1 entries as does both Ethernets,
the third Ethernet on the 192 block does not.

All the interfaces just have a bridge-group 1 entry

Globally I have the following

Bridge irb
Bridge 1 protocol ieee
Bridge 1 route ip

I can't ping through either side and when showing the bridge 1 group I get
no used stations out of 300 they are unassigned.

The versions of ios are 12.2 and 12.3.

I typed no ip routing on both boxes by the way just a s a point of
reference.

Anything obvious I've missed?