[c-nsp] ASA 5510 - 4GE SSM Problem

Krishna Kishore krishna at siticable.co.ug
Thu Aug 16 11:59:05 EDT 2007


Hi Chris,

Thanks for your reply. I try to configure the session in the ASA but it is
not creating and showing the following error.

ciscoasa(config)# session 1
Opening command session with slot 1.
Card in slot 1 did not respond to session request.

Surpricingly, the 'Status' LED in the device is glowing stable green and
power is also ok.

Any clue plz.

Regards,

Kris.

----- Original Message -----
From: "ChrisSerafin" <chris at chrisserafin.com>
To: "Krishna Kishore" <krishna.kishore at ucom.bi>
Cc: <cisco-nsp at puck.nether.net>
Sent: Thursday, August 16, 2007 5:26 PM
Subject: Re: [c-nsp] ASA 5510 - 4GE SSM Problem


> It will not show up in the ASA configs. You need to 'session 1' i
> believe into the device. This will log you into the SSM device. It has
> it's own IP addressing and GUI.  Think of it a separate device.
>
> Chris Serafin
> Security Engineer
> chris at chrisserafin.com
>
>
> Krishna Kishore wrote:
> > Hi All,
> >
> > I have a problem in installing 4 GE SSM module in my ASA 5510. I just
bought a new module 4GE SSM and installed as per the instructions. But if I
check in "sh run" I am not able to find the interfaces. Do I need to do
extra any configurations? I try to check the Cisco site but I couldn't find
a solution.
> >
> > Any clue to install it.
> >
> > Thanks in Advance,
> >
> > Kris.
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/
> >
> >
> >
> >
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>



More information about the cisco-nsp mailing list