[c-nsp] VTY locks on show commands

[Voll, Scott]

I'm thinking your correct.  I can do a "sh ver |inc xyz" and it comes
back to the prompt but if I do just a sh ver it never comes back.  I do
not believe it's a router issue because before we cut over the circuit
it worked just fine.

It's coming from a DS3 ATM and going to a Frame T1 at the end I'm having
problems with.

How do I change the MTU to fix it?  The frame circuit is in a Telco's
area I don't normally work in.

ATM side:

interface ATM4/0/0.134 point-to-point
 bandwidth 1024
 ip address 172.20.2.13 255.255.255.252
 pvc 1/34
  vbr-nrt 1024 1024
  encapsulation aal5snap

Frame side:

Serial 0/0
Encapsalation Frame-Relay ietf
No ip add

Serial0/0.16 point
Ip add 172.20.2.14 255.255.255.252
Frame-relay interface-dlci 16

Where do I change the MTU?

Scott

-----Original Message-----
From: Mikael Abrahamsson [mailto:swmike at swm.pp.se] 
Sent: Friday, June 29, 2007 2:06 PM
To: Voll, Scott
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] VTY locks on show commands

On Fri, 29 Jun 2007, Voll, Scott wrote:

> I have a router I just inherited that every time I telnet to it and
> issue a Show command it locks up.  Any idea what's causing it, and how
> to fix it?

Does it lock up even if you do "show version | inc XYZXYZ" ? If that
still 
works, it's probably an MTU issue.

-- 
Mikael Abrahamsson    email: swmike at swm.pp.se