[c-nsp] Static default route VRF not appearing

[Mark Tech]

Got it 

Cheers

Mark



----- Original Message ----
From: Oliver Boehmer (oboehmer) <oboehmer at cisco.com>
To: Mark Tech <techconfig at yahoo.com>
Cc: cisco-nsp at puck.nether.net
Sent: Wednesday, November 26, 2008 3:17:10 PM
Subject: RE: [c-nsp] Static default route VRF not appearing

Mark Tech <> wrote on Wednesday, November 26, 2008 15:44:

> Hi
> In an IP-VPN test, I need to add a static default route pointing to
> CE1 from PE1. This would I assume be redistributed to other PE's,
> then CE routers as 'redistribute static' is enabled on the PE config
> for this customer however this seems not to be the case.  
> 
> In fact PE2 never even sees that particular static route, even though
> it can see other redistributed static routes that I put in just to
> check. Is there some extra config needed on PE1 in order for the 0/0
> static route to be advertised to other PE's and therefore CE's such
> as default-originate as per standard BGP?    

yes, you need the same commands in ipv4 vrf as in "standard BGP", i.e.
default-information originate in this case.

    oli