[c-nsp] how to clear a pseudowire?

[Paolo Lucente]

Yes, it would. I guess for finer granularity you can only, and
un-elegantly, screw the circuit up by playing with the VC MTU,
at one side of it.

Cheers,
Paolo


On Fri, Nov 27, 2009 at 08:05:50PM +0200, Tassos Chatzithomaoglou wrote:
> That would kill all pseudowires with the same neighbor, wouldn't it?
>
>
> -- 
> Tassos
>
>
> Paolo Lucente wrote on 27/11/2009 11:52:
>> Hi Tassos,
>>
>> As signalling is done via targeted LDP, perhaps you want to achieve that
>> by clearing the specific LDP neighbor? 
>>
>> Cheers,
>> Paolo
>>
>> On Fri, Nov 27, 2009 at 10:15:27AM +0200, Tassos Chatzithomaoglou wrote:
>>> Is there an easy way to clear/reset a eompls pseudowire?
>>>
>>> The only (not affecting other services of the same interface) way i 
>>> have found is to remove the xconnect config from both sides, but i 
>>> was hoping that a clear command would exist.
>>>
>>> -- 
>>> Tassos
>>
>>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/