[c-nsp] optic diag commands on 6500

[Mandeep Singh]

Thanks guys for the prompt and awesome replies.
 
> Subject: Re: [c-nsp] optic diag commands on 6500
> To: s_mandeep at hotmail.com; cisco-nsp-bounces at puck.nether.net; cisco-nsp at puck.nether.net
> From: ed at edgeoc.net
> Date: Fri, 10 Jun 2011 19:57:46 +0000
> 
> Depending on IOS version and sfp's used, DOM may be useful to you.
> 
> Have a look here for compatible sfp's: http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_8031.html
> 
> #show int trans supported-mod
> #show int trans supported-list
> 
> And as others have said:
> #show int giX/X trans
> 
> - Ed
> ------Original Message------
> From: Mandeep Singh
> Sender: cisco-nsp-bounces at puck.nether.net
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] optic diag commands on 6500
> Sent: Jun 10, 2011 3:27 PM
> 
> 
> Hi,
> Is there a similar command on the 6500s as on the Junipers below:
> 
> show interfaces diagnostics optics xe-0/0/8 
> Physical interface: xe-0/0/8
> Laser bias current : 39.304 mA
> Laser output power : 0.7050 mW / -1.52 dBm
> Module temperature : 41 degrees C / 106 degrees F
> Module voltage : 3.2490 V
> Receiver signal average optical power : 0.1063 mW / -9.73 dBm
> Thanks.
> -Mandeep 
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/