[cisco-voip] 7.1(2) shared line call answer issue if not primary line

[Erick Bergquist]

This appears to be a problem with DNs on a 7914
sidecar only and not the main/base phone module. We
have the right 7914 firmware on sidecar also for
7.1(2).

--- Erick Bergquist <erickbe at yahoo.com> wrote:
> Has anyone seen this with 7.1(2)?  Always use Prime
> line is enabled also.
> 
> The problem encountered with the 7940/7960 7.1(2)
> phone load was with answering an incoming call on
> any
> Line other than the Primary Line. Prior to 7.1(2) a
> call coming in on any line could be answered by
> picking up the handset and the phone would
> automatically seek out the first active (ringing)
> line
> on the set.  With the new load, if a call comes in
> on
> any line other than the primary line the user must
> press the button for the ringing line after picking
> up
> the handset to answer that call.   For example,  if
> the user has several shared lines on a 7914 side car
> and a call comes in on one of those shared lines the
> user must first pickup the handset and then press
> the
> button on the side car for the ringing line.  Prior
> to
> 7.1(2) a ringing line on the 7914 could be answered
> by
> merely picking up the handset.  The phone would
> connect you to the ringing line without any manual
> intervention.
> 
> 
> 
> 		
> __________________________________ 
> Do you Yahoo!? 
> Yahoo! Small Business - Try our new resources site!
> http://smallbusiness.yahoo.com/resources/ 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 


		
__________________________________ 
Do you Yahoo!? 
Yahoo! Small Business - Try our new resources site!
http://smallbusiness.yahoo.com/resources/