[cisco-voip] how to load dsp firmware
Erick Bergquist
erickbe at yahoo.com
Wed Jun 7 21:03:39 EDT 2006
Here's another idea.. if you recently upgraded (the bug id has 12.4(7) as first found version) and then started having the issue, maybe you can downgrade the IOS back to where you were until a fixed IOS is available with that version DSPware.
12.4(8) is out , but I do not know what DSPware version it has. Does anyone know if there is a IOS / DSPWare version matrix anywhere? I have had good, bad, and very bad results with 12.4 versions so far so am cautious when using them and keep my fingers and toes crossed.
----- Original Message ----
From: "Ruttman, Peter G." <PRuttman at foley.com>
To: cisco-voip at puck.nether.net
Sent: Wednesday, June 7, 2006 9:22:55 AM
Subject: [cisco-voip] how to load dsp firmware
Message TAC says we may be experiencing this bug:
CSCsd54344: DSP: Persistent echo heard on c5510 DSPs with 4.4.13 DSPware or higher
Symptom:
Under certain circumstances, continual echo may be heard. The echo is perisitent and the DSP echo canceller does not converge.
Conditions:
DSPware 4.4.13 or higher on C5510 DSPs are required to experience this problem.
Workaround:
Downgrading DSPware to 4.4.12 or earlier resolves the echo issue.
TAC send is firmware and these instructions:
INSTRUCTIONS:
1. Put the file on the flash.
2. Reload the router.
3. Verify new DSP version ' sh voice dsp' (should be 4.4.18)
3. IMPORTANT: Remove file from flash after verification
However, I did the show voice dsp and saw no change in the dsp version from before getting the new dsp firmware. Can someone tell me if this is the correct way to load firmware on an NM-HDV2 on a 3745 voice gateway?
Thanks,
Pete Ruttman
CCNA CCVP
Senior Network Engineer
Foley & Lardner LLP
The preceding email message may be confidential or protected by the attorney-client privilege. It is not intended for transmission to, or receipt by, any unauthorized persons. If you have received this message in error, please (i) do not read it, (ii) reply to the sender that you received the message in error, and (iii) erase or destroy the message. Legal advice contained in the preceding message is solely for the benefit of the Foley & Lardner LLP client(s) represented by the Firm in the particular matter that is the subject of this message, and may not be relied upon by any other party.
Internal Revenue Service regulations require that certain types of written advice include a disclaimer. To the extent the preceding message contains advice relating to a Federal tax issue, unless expressly stated otherwise the advice is not intended or written to be used, and it cannot be used by the recipient or any other taxpayer, for the purpose of avoiding Federal tax penalties, and was not written to support the promotion or marketing of any transaction or matter discussed herein.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060607/93ae480e/attachment.html
More information about the cisco-voip
mailing list