[cisco-voip] Latancy / Jitter

[Bell, Joe]

According to the Enterprise QoS SRND page 1-13
(http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/ccmi
gration_09186a008049b062.pdf), your spec's are:

Voice (Bearer Traffic)

A summary of the key QoS requirements and recommendations for Voice
(bearer traffic) are:

* Voice traffic should be marked to DSCP EF per the QoS Baseline and RFC
3246.

* Loss should be no more than 1 %.

* One-way Latency (mouth-to-ear) should be no more than 150 ms.

* Average one-way Jitter should be targeted under 30 ms.

* 21-320 kbps of guaranteed priority bandwidth is required per call
(depending on the sampling

rate, VoIP codec and Layer 2 media overhead).

So, your latency is a tad bit high, but humans don't really notice it
until it is consistently above 200 ms.

Joe

 

 

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Voll, Scott
Sent: Wednesday, June 21, 2006 9:58 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Latancy / Jitter

 

I'm looking at QoS stats from CM for phone calls.  Is this out of
recommended specs?

 

Jitter < 15

Lantancy < 175

 

Thanks

 

Scott



This message and any attachments are intended only for the use of the addressee and may contain information that is privileged and confidential. If the reader of the message is not the intended recipient or an authorized representative of the intended recipient, you are hereby notified that any dissemination of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail and delete the message and any attachments from your system.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060621/c0c1568e/attachment-0001.html