[cisco-voip] Caller ID with Verizon

IT it at cimgroup.com
Tue Mar 14 13:38:50 EST 2006 

Carlos,

Thanks for the reply, I thought that as well, but I confirmed that they
have all the correct phone numbers in their "screening table". Does
anyone have a gateway with Verizon in the DC area who can verify my PRI
configuration?

Thanks,

Avidan

 

 

________________________________

From: Ortiz, Carlos [mailto:CORTIZ at broward.org] 
Sent: Tuesday, March 14, 2006 5:49 AM
To: Voll, Scott; IT; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Caller ID with Verizon

 

Down here in Florida this happens when Bellsouth only has the main line
in their "screening table".  In other words, If they don't recognize the
called from number in their screening table they output the main line or
billing number.  Could this be your issue?  

 

Carlos

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Voll, Scott
Sent: Tuesday, March 14, 2006 12:41 AM
To: IT; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Caller ID with Verizon

 

I don't know about Verizon in MD but in OR you have to pay a $200 to
setup the service and $75 a month to keep it.

 

Scott

 

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of IT
Sent: Mon 3/13/2006 8:17 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Caller ID with Verizon

I am dealing with issues on my PRI in Bethesda, MD with Verizon. I have
used the exact same configuration as with my gateways in California
(with SBC/att), but I have the following problem. When I make any calls
through the gateway, I pass the caller-id information, but the called
party gets the generic "main line" number for the office as the calling
party.
For example, I have attached the output below of me calling my cellphone
through this PRI from extension 3581.
Notice that the calling party is 3014693581, but I call my cellphone and
it appears as 3014693580.
For reference, here is a link to a screen shot of my PRI config from
CallManager.
http://www.avidanross.com/pri_config.pdf

Thanks,
Avidan

DEBUG ISDN Q931 OUTPUT
-----------------------
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 DTMF_TONE_DET
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 FAX
*Mar 13 21:57:20:                 CODEC_BYTES
*Mar 13 21:57:20:                 NTE_PAYLOAD
*Mar 13 21:57:20:                 DTMF_RELAY
*Mar 13 21:57:20:                 NSE_PAYLOAD
*Mar 13 21:57:20:                 SIGNAL_TYPE
*Mar 13 21:57:20:                 FAX_BYTES
*Mar 13 21:57:20:                 NTE_TX_PAYLOAD
*Mar 13 21:57:20:                 SEQ_NUM_START
*Mar 13 21:57:20:                 MP_CAP_MODEM_PROTO
*Mar 13 21:57:20:                 MP_CAP_MODEM_CODEC
*Mar 13 21:57:20:                 MP_CAP_VOICE_RTP_NSE_PAYLOAD
*Mar 13 21:57:20:                 MR_INFO
*Mar 13 21:57:20:                 IP_TONE_HANDLER
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 FAX_TONE_DET
*Mar 13 21:57:20:                 MODEM_TONE_DET
*Mar 13 21:57:20:                 CM_TONE_DET
*Mar 13 21:57:20:                 PER_CALL_DEBUG
*Mar 13 21:57:20: ISDN Se0/2/0:23 Q931: TX -> SETUP pd = 8  callref =
0x0006
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98397
                Exclusive, Channel 23
        Calling Party Number i = 0x2881, '3014693581'
                Plan:National, Type:National
        Called Party Number i = 0xA1, '13239439922'
                Plan:ISDN, Type:National
*Mar 13 21:57:20: ISDN Se0/2/0:23 Q931: RX <- CALL_PROC pd = 8  callref
= 0x8006

        Channel ID i = 0xA98397
                Exclusive, Channel 23
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 DTMF_TONE_DET
*Mar 13 21:57:20:                 FAX_TONE_DET
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 DTMF_TONE_DET
*Mar 13 21:57:20:                 FAX_TONE_DET
*Mar 13 21:57:25: ISDN Se0/2/0:23 Q931: RX <- PROGRESS pd = 8  callref =
0x8006
        Progress Ind i = 0x8488 - In-band info or appropriate now
available
*Mar 13 21:57:26: ISDN Se0/2/0:23 Q931: RX <- ALERTING pd = 8  callref =
0x8006
*Mar 13 21:57:27: Modify Nominator =
*Mar 13 21:57:27:                 DTMF_TONE_DET
*Mar 13 21:57:27: Modify Nominator =
*Mar 13 21:57:27:                 DTMF_TONE_DET
*Mar 13 21:57:27: ISDN Se0/2/0:23 Q931: TX -> DISCONNECT pd = 8  callref
= 0x000
6
        Cause i = 0x8090 - Normal call clearing
*Mar 13 21:57:27: ISDN Se0/2/0:23 Q931: RX <- RELEASE pd = 8  callref =
0x8006
*Mar 13 21:57:27: ISDN Se0/2/0:23 Q931: TX -> RELEASE_COMP pd = 8
callref = 0x0
006

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060314/d9c6da06/attachment-0001.html

More information about the cisco-voip mailing list