[cisco-voip] Configuring ATA for Faxing (Modem Passthru)
Jason Aarons (US)
jason.aarons at us.didata.com
Mon Oct 16 15:12:07 EDT 2006
What is the equivalent command in MGCP to the two below router H.323
commands?
Config t
Voice service voip
modem passthrough nse codec g711ulaw
dial-peer voice XXXXXXX voip
modem passthrough nse codec g711ulaw
Reference
http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_
chapter09186a008053b51f.html
If you add the above then you MUST change the ATA (http://X.Y.Z.A/dev)
Audio Parameters
AudioMode 0x00150015 (default is 0x00350035)
ConnectMode 0x90000400 (default is 0x90000400)
-----------------------------------------
Disclaimer:
This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only. If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful. If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061016/6fb0c34f/attachment.html
More information about the cisco-voip
mailing list