[cisco-voip] CCM4.1 to GK to MCU...
Ryan Ratliff
rratliff at cisco.com
Mon Oct 30 13:07:10 EST 2006
You have to have a route pattern pointing to the trunk for CM to
register with the gk afaik. Also note that CM only retries
registration every 30-60 seconds. For quicker results reset the gk-
controlled trunk. Also make sure you have CM set to register as a
gateway not a terminal.
From your config I assume CM's IP address falls within the
10.1.1.0/22 subnet?
-Ryan
On Oct 30, 2006, at 12:38 PM, Jonathan Charles wrote:
OK, I have a CCM4.1 box, and I am trying to get it to connect (for
video) to a Cisco MCU, via a gatekeeper...
The MCU is registered to the gatekeeper as an endpoint, but I can't
get the CCM to do the same...
I have a gatekeeper controlled trunk pointing at the MCU (with the GK
identified)...
Still nothing...
I also added a couple of route-patterns (with the MCU service
prefixes) pointing at the trunk... Still nothing...
gatekeeper
zone local 10.1.1.1 binky.com
zone subnet 10.1.1.1 10.1.1.0/22 enable
zone prefix 10.1.1.1 2125554244*
gw-type-prefix 1#* default-technology
no shutdown
Any ideas?
TIA
Jonathan
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
More information about the cisco-voip
mailing list