[cisco-voip] CCM4.1 to GK to MCU...
Ryan Ratliff
rratliff at cisco.com
Mon Oct 30 14:42:32 EST 2006
Check that zone subnet command. I'm pretty sure it restricts what IP
addresses the gatekeeper will allow registration from. Also check
out 'debug ras', 'debug h225 asn1', and 'debug gatek main 10'.
-Ryan
On Oct 30, 2006, at 1:52 PM, Jonathan Charles wrote:
There is a route-pattern pointing to the trunk, but the Gatekeeper
only shows the MCU registered as an endpoint.
The CM is set to register as a gateway... and the CM is not on the
same subnet...
Jonathan
On 10/30/06, Ryan Ratliff <rratliff at cisco.com> wrote: You have to
have a route pattern pointing to the trunk for CM to
register with the gk afaik. Also note that CM only retries
registration every 30-60 seconds. For quicker results reset the gk-
controlled trunk. Also make sure you have CM set to register as a
gateway not a terminal.
From your config I assume CM's IP address falls within the
10.1.1.0/22 subnet?
-Ryan
On Oct 30, 2006, at 12:38 PM, Jonathan Charles wrote:
OK, I have a CCM4.1 box, and I am trying to get it to connect (for
video) to a Cisco MCU, via a gatekeeper...
The MCU is registered to the gatekeeper as an endpoint, but I can't
get the CCM to do the same...
I have a gatekeeper controlled trunk pointing at the MCU (with the GK
identified)...
Still nothing...
I also added a couple of route-patterns (with the MCU service
prefixes) pointing at the trunk... Still nothing...
gatekeeper
zone local 10.1.1.1 binky.com
zone subnet 10.1.1.1 10.1.1.0/22 enable
zone prefix 10.1.1.1 2125554244*
gw-type-prefix 1#* default-technology
no shutdown
Any ideas?
TIA
Jonathan
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
More information about the cisco-voip
mailing list