[cisco-voip] CMM ACT FastEthernet 2/0

[Jason Aarons (US)]

Can anyone post a sanitized CMM config, in particular I'm looking for
the FastEthernet 2/0 setup in relation to the ACT dspfarm
profile/sccp..the one I'm using on CCO shows Gig1/0 and FastEthernet 2/0
overlapping , when I configure this CMM compains about overlapping
address (search the CCO link below for 10.1.2.36 on Gigabit2/0 and
10.1.2.37 on FastEthernet2/0). The CCO article implies you can bind the
RTP audio stream of the conference bridge to FastEthernet2/0 versus
GigabitEthernet 1/0 for control of SCCP.

 

http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/products_feature_
guide09186a00805ae839.html#wp1068910

 




-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070202/4fa8cd91/attachment-0001.html