[cisco-voip] CMM ACT FastEthernet 2/0

[Voll, Scott]

 associate profile 2 register MTP001192b75643

 associate profile 1 register CFB001192b75643

 

 

that is the mac address of the FE.  Do A show ARP to get the right Mac
for FE.

 

 

Yes I'm MoH to the PRI card.

 

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons
(US)
Sent: Friday, February 02, 2007 2:46 PM
To: cisco-voip at puck-nether.net
Subject: Re: [cisco-voip] CMM ACT FastEthernet 2/0

 

Where are you binding the conference bridge rtp to FastEthernet 2/0? Are
you multicasting from CallManager to the 6-T1 module for MoH?

 

I'm not clear how the application knows which interface to use.

 

Ok I see you put a host subnet address for FastEthernet 2/0, I'll try
that -jason

 

From: Voll, Scott [mailto:Scott.Voll at wesd.org] 
Sent: Friday, February 02, 2007 5:43 PM
To: Jason Aarons (US); cisco-voip at puck-nether.net
Subject: RE: [cisco-voip] CMM ACT FastEthernet 2/0

 

Check the Subnet!!

 

***********************************************

 

 

interface FastEthernet0/0

 ip address 10.x.x.6 255.255.255.255

 no ip proxy-arp

 full-duplex

!

interface GigabitEthernet1/0

 ip address 10.x.x.5 255.255.255.0

 no ip proxy-arp

 ip pim sparse-dense-mode

 no negotiation auto

 no keepalive

 

ip route 0.0.0.0 0.0.0.0 10.x.x.1

!

!

mediacard 1

 resource-pool Ad-Hoc dsps 2

 resource-pool transcode dsps 2

!

!

sccp local GigabitEthernet1/0

sccp ccm 10.x.x.35 identifier 2

sccp ccm 10.x.x.36 identifier 1

sccp

!

sccp ccm group 1

 associate ccm 2 priority 2

 associate ccm 1 priority 1

 associate profile 2 register MTP001192b75643

 associate profile 1 register CFB001192b75643

!

dspfarm

!

dspfarm profile 1 conference adhoc

 codec g711ulaw packetization-period 30

 codec g711alaw packetization-period 30

 codec g729r8 packetization-period 30

 codec g729ar8 packetization-period 30

 codec g723r63 packetization-period 30

 codec g723r53 packetization-period 30

 associate resource-pool Ad-Hoc

!

dspfarm profile 2 transcode

 codec g711ulaw packetization-period 30

 codec g711alaw packetization-period 30

 codec g729r8 packetization-period 30

 codec g729ar8 packetization-period 30

 codec g723r63 packetization-period 30

 codec g723r53 packetization-period 30

 associate resource-pool transcode

!

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons
(US)
Sent: Friday, February 02, 2007 2:32 PM
To: cisco-voip at puck-nether.net
Subject: [cisco-voip] CMM ACT FastEthernet 2/0

 

Can anyone post a sanitized CMM config, in particular I'm looking for
the FastEthernet 2/0 setup in relation to the ACT dspfarm
profile/sccp..the one I'm using on CCO shows Gig1/0 and FastEthernet 2/0
overlapping , when I configure this CMM compains about overlapping
address (search the CCO link below for 10.1.2.36 on Gigabit2/0 and
10.1.2.37 on FastEthernet2/0). The CCO article implies you can bind the
RTP audio stream of the conference bridge to FastEthernet2/0 versus
GigabitEthernet 1/0 for control of SCCP.

 

http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/products_feature_
guide09186a00805ae839.html#wp1068910

 

________________________________

Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee,
you are hereby notified that you have received this communication in
error and that any use or reproduction of this email or its contents is
strictly prohibited and may be unlawful. If you have received this
communication in error, please notify us immediately by replying to this
message and deleting it from your computer. Thank you. 

________________________________

Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee,
you are hereby notified that you have received this communication in
error and that any use or reproduction of this email or its contents is
strictly prohibited and may be unlawful. If you have received this
communication in error, please notify us immediately by replying to this
message and deleting it from your computer. Thank you. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070202/9597f4b2/attachment.html