[cisco-voip] CMM ACT FastEthernet 2/0

Fri Feb 2 18:19:44 EST 2007

...don't feel stupid, that's what this list is for. 

to help translate the cisco-eeze. ;)

--------------------------------------------------------------------------------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
...there's no such thing as a bad timbit...

  ----- Original Message ----- 
  From: Jason Aarons (US) 
  To: Voll, Scott ; cisco-voip at puck-nether.net 
  Sent: Friday, February 02, 2007 6:05 PM
  Subject: Re: [cisco-voip] CMM ACT FastEthernet 2/0

  Ok, I feel stupid.I knew this.

  I've done enough ISRs dspfarms, guess I'm reading too much into the CCO articles about there being a "bind" command for the CMM blade.

  From: Voll, Scott [mailto:Scott.Voll at wesd.org] 
  Sent: Friday, February 02, 2007 6:01 PM
  To: Jason Aarons (US); cisco-voip at puck-nether.net
  Subject: RE: [cisco-voip] CMM ACT FastEthernet 2/0

   associate profile 2 register MTP001192b75643

   associate profile 1 register CFB001192b75643

  that is the mac address of the FE.  Do A show ARP to get the right Mac for FE.

  Yes I'm MoH to the PRI card.

------------------------------------------------------------------------------

  From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons (US)
  Sent: Friday, February 02, 2007 2:46 PM
  To: cisco-voip at puck-nether.net
  Subject: Re: [cisco-voip] CMM ACT FastEthernet 2/0

  Where are you binding the conference bridge rtp to FastEthernet 2/0? Are you multicasting from CallManager to the 6-T1 module for MoH?

  I'm not clear how the application knows which interface to use.

  Ok I see you put a host subnet address for FastEthernet 2/0, I'll try that -jason

  From: Voll, Scott [mailto:Scott.Voll at wesd.org] 
  Sent: Friday, February 02, 2007 5:43 PM
  To: Jason Aarons (US); cisco-voip at puck-nether.net
  Subject: RE: [cisco-voip] CMM ACT FastEthernet 2/0

  Check the Subnet!!

  ***********************************************

  interface FastEthernet0/0

   ip address 10.x.x.6 255.255.255.255

   no ip proxy-arp

   full-duplex

  !

  interface GigabitEthernet1/0

   ip address 10.x.x.5 255.255.255.0

   no ip proxy-arp

   ip pim sparse-dense-mode

   no negotiation auto

   no keepalive

  ip route 0.0.0.0 0.0.0.0 10.x.x.1

  !

  !

  mediacard 1

   resource-pool Ad-Hoc dsps 2

   resource-pool transcode dsps 2

  !

  !

  sccp local GigabitEthernet1/0

  sccp ccm 10.x.x.35 identifier 2

  sccp ccm 10.x.x.36 identifier 1

  sccp

  !

  sccp ccm group 1

   associate ccm 2 priority 2

   associate ccm 1 priority 1

   associate profile 2 register MTP001192b75643

   associate profile 1 register CFB001192b75643

  !

  dspfarm

  !

  dspfarm profile 1 conference adhoc

   codec g711ulaw packetization-period 30

   codec g711alaw packetization-period 30

   codec g729r8 packetization-period 30

   codec g729ar8 packetization-period 30

   codec g723r63 packetization-period 30

   codec g723r53 packetization-period 30

   associate resource-pool Ad-Hoc

  !

  dspfarm profile 2 transcode

   codec g711ulaw packetization-period 30

   codec g711alaw packetization-period 30

   codec g729r8 packetization-period 30

   codec g729ar8 packetization-period 30

   codec g723r63 packetization-period 30

   codec g723r53 packetization-period 30

   associate resource-pool transcode

  !

------------------------------------------------------------------------------

  From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons (US)
  Sent: Friday, February 02, 2007 2:32 PM
  To: cisco-voip at puck-nether.net
  Subject: [cisco-voip] CMM ACT FastEthernet 2/0

  Can anyone post a sanitized CMM config, in particular I'm looking for the FastEthernet 2/0 setup in relation to the ACT dspfarm profile/sccp..the one I'm using on CCO shows Gig1/0 and FastEthernet 2/0 overlapping , when I configure this CMM compains about overlapping address (search the CCO link below for 10.1.2.36 on Gigabit2/0 and 10.1.2.37 on FastEthernet2/0). The CCO article implies you can bind the RTP audio stream of the conference bridge to FastEthernet2/0 versus GigabitEthernet 1/0 for control of SCCP.

  http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/products_feature_guide09186a00805ae839.html#wp1068910

------------------------------------------------------------------------------

  Disclaimer: This e-mail communication and any attachments may contain confidential and privileged information and is for use by the designated addressee(s) named above only. If you are not the intended addressee, you are hereby notified that you have received this communication in error and that any use or reproduction of this email or its contents is strictly prohibited and may be unlawful. If you have received this communication in error, please notify us immediately by replying to this message and deleting it from your computer. Thank you. 

------------------------------------------------------------------------------

  Disclaimer: This e-mail communication and any attachments may contain confidential and privileged information and is for use by the designated addressee(s) named above only. If you are not the intended addressee, you are hereby notified that you have received this communication in error and that any use or reproduction of this email or its contents is strictly prohibited and may be unlawful. If you have received this communication in error, please notify us immediately by replying to this message and deleting it from your computer. Thank you. 

------------------------------------------------------------------------------

  Disclaimer: This e-mail communication and any attachments may contain confidential and privileged information and is for use by the designated addressee(s) named above only. If you are not the intended addressee, you are hereby notified that you have received this communication in error and that any use or reproduction of this email or its contents is strictly prohibited and may be unlawful. If you have received this communication in error, please notify us immediately by replying to this message and deleting it from your computer. Thank you. 

------------------------------------------------------------------------------

  _______________________________________________
  cisco-voip mailing list
  cisco-voip at puck.nether.net
  https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070202/e091efe0/attachment-0001.html 