[cisco-voip] how to config vg248 to send disconnect

[Jason Aarons (US)]

FXS for paging isn't a good design due to varying disconnect supervison
across products.  For example a ATA-186 with Valcom 9987 works in CME
but not CCM due to software design.

 

 You should be using a FXO interface and something like a Valcom 2002-A.

 

I would call your paging vendor (Bogen, Valcom, etc) and ask them for a
best practice design.

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of James Grace
Sent: Friday, February 09, 2007 1:10 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] how to config vg248 to send disconnect

 

?

im trying to hook up a paging unit and all works except the disconnect
from the port of the vg248.  so im getting a busy and dial tone over my
speakers when i hang up.  Can someone help me with this 

 

James Grace 

 

Systems Engineer

Adcap Network Systems, Inc.

6865 Shiloh Road East, Suite 250

Alpharetta, GA 30005

 

office: 678-456-6986

direct: 678-456-6761

jgrace at adcapnet.com

www.adcapnet.com <http://www.adcapnet.com/> 



-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070209/2e627855/attachment.html