[cisco-voip] Fax config for fxs in MGCP

[Anthony Kouloglou]

Hi,
i have a 2801 with a vic2-2bri and 4fxs voice ports.

Also the ccm is 5.0(x) and the gateway is configured as MGCP (I just 
hate MGCP for these implementation but i found it configured and i 
didn't want to change it!!Otherwise i would use H323 which i think 
behaves better)

A specific number that hits bri, gets translated and points to the 
faxmodem attached at the fxs.
This scenario works fine with voice (no extra congif needed) but

in order to receive/send fax with no problems, is there something else i 
must add in:

Bri port config via CCMadmin page?
fxs port config via CCMadmin page?
bri port in IOS?
fxs port in IOS?
MGCP config in IOS?

Thanks
Anthony