[cisco-voip] PLEASE REMOVE MILLERMAN1 at cox.net from the List!

[Steve Miller]

Thank you!  I will keep my work address.

---- Justin Steinberg <jsteinberg at gmail.com> wrote: 
> If I understand you correctly, you have two Avaya PBX's and each PBX is
> connected via T1 to a Cisco Router which in turn connects the PBXs over an
> IP WAN.
> 
> If you are scrapping one of the Avaya PBXs altogether and the Cisco routers
> are configured via T-CCS as explained in the link from my email below you
> are in trouble.  You will need to reconfigure your remaining Avaya to some
> signaling type where the dialed number can be interpreted and routed by
> Cisco routers.
> 
> If the existing Cisco routers are not configured with T-CCS and are
> configured with normal voip dial-peers you will be fine.
> 
> HTH,
> 
> Justin
> 
> 
> On 2/22/07, Robert Kulagowski <bob at smalltime.com> wrote:
> >
> > Justin Steinberg wrote:
> > > Configuration depends on your Avaya setup.
> > >
> > > You'll want to read this:
> > >
> > >
> > http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a00800e9761.html#wp1019465
> > > <
> > http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a00800e9761.html#wp1019465
> > >
> >
> > My admittedly quick glance shows the router are sitting inbetween two
> > Avaya PBX.  I'm actually going to have the router terminating the calls
> > and sending them to 7970s because one of the Avaya's is going away
> > entirely.  Would this document still apply in this case?
> >
> >