[cisco-voip] CUCM 6.1 SIP Trunk to Provider

[Alessandro Bertacco]

Hi all,

  I’ll need to configure a SIP trunk from a CUCM6.1 to an external provider,
to route incoming call to a specified Phone.

 

Someone have already configured CUCM6.1 to do these? I need an Ip to Ip
Gateway or not?

Can I use the Voice Gateway instead of IP to IP dedicated Router?

 

Thank you for your response

 

Best Regards

 

Alessandro Bertacco

 

Da: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] Per conto di Lelio Fulgenzi
Inviato: giovedì 31 luglio 2008 20.37
A: Cisco Voyp List
Oggetto: [cisco-voip] Setting up a SIP trunk...anything special?

 

I am setting up a SIP trunk to a Cistera appliance (I believe they are using
asterisk) in order for the box to dial out. The SIP trunk setup went fine
and without incident. Is there anything else I need to do? Someone mentioned
to me a while back that I would need something else like a transcoder.

 

Any pointers would be great.

 

Thanks,

 

Lelio
----------------------------------------------------------------------------
----
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
...seen on a Geek Squad patch cord: "While it is the same length, this 7'
crossover cable
is not regulation issue for most competitive Manhattan double dutch leagues.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080806/c73fba8e/attachment-0001.html>