[cisco-voip] platformConfig.xml causes halt and re-install media

[Ryan Ratliff]

The platformconfig.xml file is where it gets all of the info it would  
normally prompt you for during the initial setup.  If it can't read  
the file then it can't get this info (including hostname, networking  
parameters, etc) how can it proceed with the install?  At best it  
could fall back to prompting the user for all of the info but forcing  
you to start over doesn't extend the install time by more than a few  
minutes at worst.

-Ryan

On Aug 6, 2008, at 1:32 PM, Jason Aarons ((US)) wrote:

Pre-configured 7815H3 server did a halt with USB provided  
platformConfig.xml under 6.1.2-1000-13 stating it couldn’t properly  
read the file.



You would think the software would ignore a bad platformConfig.xml  
and continue one.  I assume I have to re-run install from DVD…







Disclaimer: This e-mail communication and any attachments may contain  
confidential and privileged information and is for use by the  
designated addressee(s) named above only. If you are not the intended  
addressee, you are hereby notified that you have received this  
communication in error and that any use or reproduction of this email  
or its contents is strictly prohibited and may be unlawful. If you  
have received this communication in error, please notify us  
immediately by replying to this message and deleting it from your  
computer. Thank you.

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080807/8be12b19/attachment.html>