[cisco-voip] CCM and FXO on 2801

[Joe Cisco]

If you telnet to the gateway, do a "terminal monitor" then issue a
"debug vpm all". Try to dial out. If your ROUTE PATTERN(S) / ROUTE
LIST(S) / ROUTE GROUP(S) are configured properly, you should see the
call attempt to go out one of the FXO ports. If not, go back and trace
thru the RPs/RLs/RGs and see if everything looks correct - especially
make sure the route list is registered.

Also, because it is MGCP, assuming you are using a lead 8 or lead 9
for an outside access code, be sure you strip it off (probably in the
route pattern) before you send the call out the gateway - UNLESS for
some reason the POTS line is a plexar line and it expects a lead 9.

-Joe C.

On Wed, Jul 23, 2008 at 10:27 PM, Mark J <markju at gmail.com> wrote:
> Thanks for prompt reply...
>
> Using MGCP
>
> Thanks
>
> 2008/7/24 Joe Cisco <smetsysocsic at gmail.com>:
>>
>> Are you using MGCP or H323?
>>
>> -Joe C.
>>
>> On Wed, Jul 23, 2008 at 10:07 PM, Mark J <markju at gmail.com> wrote:
>> > Hey guys,
>> >
>> > I'm having an issues getting the FXO ports (outbound calls) working
>> > successfully working on 2811 thru CCM.
>> >
>> > I have inbound calls working fine, just can't get outbound calls
>> > working,
>> > output tone is like a busy signal.
>> >
>> > Does anyone have a config that is working so that I can compare my
>> > config?
>> >
>> > Thanks.
>> >
>> > _______________________________________________
>> > cisco-voip mailing list
>> > cisco-voip at puck.nether.net
>> > https://puck.nether.net/mailman/listinfo/cisco-voip
>> >
>> >
>
>