[cisco-voip] ISDN - Cause i = 0x80A9 - Temporary failure

[Peter Slow]

what version of IOS are you running on the CMM? you took the important
information out of the sh ver =)

is this gatewawy MGCP or H.323?

-Peter

On 6/18/08, Perera, Manoj (GE, Corporate) <manoj.perera at ge.com> wrote:
>
> Hi All,
> We have CMM module voice gateway with 5 T1 lines. One user is reported today
> that he don't receive calls from outside. I checked the call manager
> settings and everything looks okay. When debug on voice gateway, I found
> that "Temporary failure" error as bellow. I have checked other phones using
> same gateway but didn't find any issue. So, currently this happen to only
> one phone. Any help would be greatly appreciated.
>
> Thanks,
>
> Manoj
>
>
>
> Jun 18 10:45:00.570: ISDN Se1/3:23 Q931: RX <- SETUP pd = 8  callref =
> 0x0082
>         Bearer Capability i = 0x8090A2
>                 Standard = CCITT
>                 Transfer Capability = Speech
>                 Transfer Mode = Circuit
>                 Transfer Rate = 64 kbit/s
>         Channel ID i = 0xA193080000
>                 Preferred, Channel 8
>         Calling Party Number i = 0x0083, '090XXXXXXXX'
>                 Plan:Unknown, Type:Unknown
>         Called Party Number i = 0x80, '35XXXXX'
>                 Plan:Unknown, Type:Unknown
> Jun 18 10:45:00.590: ISDN Se1/3:23 Q931: TX -> CALL_PROC pd = 8  callref =
> 0x8082
>         Channel ID i = 0xA98394
>                 Exclusive, Channel 20
> Jun 18 10:45:00.590: ISDN Se1/3:23 Q931: TX -> DISCONNECT pd = 8  callref =
> 0x8082
>         Cause i = 0x80A9 - Temporary failure
> Jun 18 10:45:00.758: ISDN Se1/3:23 Q931: RX <- RELEASE pd = 8  callref =
> 0x0082
> Jun 18 10:45:00.766: ISDN Se1/3:23 Q931: TX -> RELEASE_COMP pd = 8  callref
> = 0x8082
>
>
>
> cisco WS-SVC-CMM Cat6k Voice Linecard (R7000) processor (revision 0xFF) with
> 196608K/65536K bytes of memory.
> Processor board ID SAD102005LR
> R7000 CPU at 400MHz, Implementation 39, Rev 3.3, 256KB L2 Cache
> Last reset from power-on
> 2 FastEthernet interfaces
> 1 Gigabit Ethernet interface
> 144 Serial interfaces
> 6 Channelized T1/PRI ports
> 32768K bytes of processor board bootflash (Read/Write)
>
> Configuration register is 0x102
>
>
> XXXXXXXXXXXX01#show controllers t1
> T1 1/0 is up.
>   Applique type is Channelized T1
>   Cablelength is long gain36 0db
>   No alarms detected.
>   alarm-trigger is not set
>   Soaking time: 3, Clearance time: 10
>   AIS State:Clear  LOS State:Clear  LOF State:Clear
>   Framing is ESF, Line Code is B8ZS, Clock Source is Line.
>   Data in current interval (515 seconds elapsed):
>      0 Line Code Violations, 0 Path Code Violations
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
>   Total Data (last 24 hours)
>      0 Line Code Violations, 0 Path Code Violations,
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
> T1 1/1 is up.
>   Applique type is Channelized T1
>   Cablelength is long gain36 0db
>   No alarms detected.
>   alarm-trigger is not set
>   Soaking time: 3, Clearance time: 10
>   AIS State:Clear  LOS State:Clear  LOF State:Clear
>   Framing is ESF, Line Code is B8ZS, Clock Source is Line.
>   Data in current interval (516 seconds elapsed):
>      0 Line Code Violations, 0 Path Code Violations
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
>   Total Data (last 24 hours)
>      0 Line Code Violations, 0 Path Code Violations,
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
> T1 1/2 is up.
>   Applique type is Channelized T1
>   Cablelength is long gain36 0db
>   No alarms detected.
>   alarm-trigger is not set
>   Soaking time: 3, Clearance time: 10
>   AIS State:Clear  LOS State:Clear  LOF State:Clear
>   Framing is ESF, Line Code is B8ZS, Clock Source is Line.
>   Data in current interval (517 seconds elapsed):
>      0 Line Code Violations, 0 Path Code Violations
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
>   Total Data (last 24 hours)
>      0 Line Code Violations, 0 Path Code Violations,
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
> T1 1/3 is up.
>   Applique type is Channelized T1
>   Cablelength is long gain36 0db
>   No alarms detected.
>   alarm-trigger is not set
>   Soaking time: 3, Clearance time: 10
>   AIS State:Clear  LOS State:Clear  LOF State:Clear
>   Framing is ESF, Line Code is B8ZS, Clock Source is Line.
>   Data in current interval (517 seconds elapsed):
>      0 Line Code Violations, 0 Path Code Violations
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
>   Total Data (last 24 hours)
>      0 Line Code Violations, 0 Path Code Violations,
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
> T1 1/4 is down.
>   Applique type is Channelized T1
>   Cablelength is long gain36 0db
>   Receiver has loss of signal.
>   alarm-trigger is not set
>   Soaking time: 3, Clearance time: 10
>   AIS State:Clear  LOS State:Clear  LOF State:Clear
>   Framing is ESF, Line Code is B8ZS, Clock Source is Line.
>   Data in current interval (517 seconds elapsed):
>      0 Line Code Violations, 0 Path Code Violations
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 517 Unavail
> Secs
>   Total Data (last 24 hours)
>      0 Line Code Violations, 0 Path Code Violations,
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail
> Secs
> T1 1/5 is up.
>   Applique type is Channelized T1
>   Cablelength is long gain36 0db
>   No alarms detected.
>   alarm-trigger is not set
>   Soaking time: 3, Clearance time: 10
>   AIS State:Clear  LOS State:Clear  LOF State:Clear
>   Framing is ESF, Line Code is B8ZS, Clock Source is Line.
>   Data in current interval (518 seconds elapsed):
>      0 Line Code Violations, 0 Path Code Violations
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
>   Total Data (last 24 hours)
>      0 Line Code Violations, 0 Path Code Violations,
>      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>