[cisco-voip] 7906 phones stopped working with CME

[Nikola Stojsin]

I would try replacing the firmware file - I ran into a similar problem once
before, and problem was traced back to (invisible) data corruption...

HTH,
Nikola

 
 
------------------------------
Nikola Stojsin
PhD CCIE #12888
Nikola at att.net
(917) 558-1423
(917) 591-9382 (fax)
------------------------------
 
 
-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Erick Bergquist
Sent: Friday, September 12, 2008 5:55 PM
To: ROZA, Ariel
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] 7906 phones stopped working with CME

Yep, all that has been there for awhile. These phones were working fine.

On Fri, Sep 12, 2008 at 4:36 PM, ROZA, Ariel
<Ariel.ROZA at la.logicalis.com> wrote:
> Eric,
>
>        You must have the phone firmware file on the router´s flash memory,
and make sure that you have the tftp-server command applied too...
>
> Regards,
>
> Ariel
>
> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Erick Bergquist
> Sent: Viernes, 12 de Septiembre de 2008 06:30 p.m.
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] 7906 phones stopped working with CME
>
> Hi,
>
> I have a strange issue, have about 15 7906 model phones on a CME 4.1
system and all of sudden all the 7906 phones except 1 no longer function
correctly. They worked fine before. They just keep cycling trying to do
something, if we put a 7911 model phone on same cable, same switch port, etc
it works fine. We've rebooted the CME router also even and the phone is
getting a DHCP address from the DHCP server and I can ping it briefly as it
cycles.
>
> On the phone itself, you power it on, the lights blink, then after a
couple seconds the Cisco logo is displayed on the LCD and in corner there is
square with a checkmark in it on first cycle after a power on.
> On subsequent cycles the phone does, it displays logo with a circle in
corner with a diamond or square in the circle (can't really make it out).
>
> What is the factory reset procedure for the 7906?
> I tried powering it on with holding down # key and then releasing when it
lights up, then entering the 123456789*#0 sequence but that did not make any
difference and I let it sit for 15 minutes after doing that.
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip