[cisco-voip] FXS port as extension

[Ian Tait]

Thanks,

I'll check that out.

Ian

> -----Original Message-----
> From: Peter Slow [mailto:peter.slow at gmail.com] 
> Sent: 22 February 2009 22:22
> To: Mark Holloway; Ian Tait
> Cc: cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] FXS port as extension
> 
> Ian,
>   You'd probably see a benefit from using SCCP to control 
> this FXS port, this should work with CUCM or CME. I do not 
> know if this is supported on a 3640 but based on your IOS 
> version, I am assuming you should be able to use the feature, 
> since you are on 12.4 mainline and it was introduced in 12.3T.
>   This would allow you use of some of CCM's supplementary 
> services for the FXS-connected devices.
> 
> check out this link:
> http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/gu
> ide/fxssccpsplmft.html
> 
> -Peter
> 
> On Sun, Feb 22, 2009 at 4:56 PM, Mark Holloway 
> <mh at markholloway.com> wrote:
> > You do realize ephone stands for Ethernet phone, right?   
> Try a POTS dial
> > peer for your FXS port.
> >
> >
> > -----Original Message-----
> > From: cisco-voip-bounces at puck.nether.net
> > [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ian Tait
> > Sent: Sunday, February 22, 2009 11:59 AM
> > To: cisco-voip at puck.nether.net
> > Subject: [cisco-voip] FXS port as extension
> >
> > Lads and lasses,
> >
> > I'm missing something in my setup.
> >
> > I've got a 3640 with 2 FXS ports, from which I can make calls, and 
> > calling a local IP phone from an analogue phone attached to 
> one of the 
> > FXS ports, show up as the correct extension, but I can't call the 
> > analogue extension from any other phone - busy tone.
> >
> > IOS 12.4(21)
> >
> > Relevant bits of config:
> >
> > ! FXS port...
> >
> > voice-port 0/0/0
> >
> >  station-id name 0
> >
> >  station-id number 1004
> >
> >
> > ! dn for analogue phone...
> > ephone-dn  4
> >
> >  number 1004
> >
> >
> > I'm guessing I need to figure out the mac address of the 
> port to put 
> > it in the 'ephone 4' section, which is pretty bare at the mo :-)
> >
> > If so, how do I do that? :-) Or what else may I have missed?
> >
> > Thanks,
> >
> > Ian
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
>