Re: [nsp] "ip nat inside" question

From: David Wilde (dwilde@aapt.com.au)
Date: Wed May 29 2002 - 19:09:39 EDT

Next message: MPLS Newbie: "[nsp] Can you mix POS,ATM and Ethernet interfaces in a vlan on a catalyst"
Previous message: Badat, Qassim, ALCNS: "[nsp] TACACS"
Maybe in reply to: TMS: "[nsp] "ip nat inside" question"
Next in thread: David Wilde: "Re: [nsp] "ip nat inside" question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Hiya,

Yes, you do - see http://www.cisco.com/warp/customer/556/12.html for examples vaguely similar to this.

Regards,

David

>>> TMS <tomek@absolut.vinyl.pl> 05/29/02 06:50pm >>>
I have configuration which looks like that:

ISP --> S1/0 S1/1 --------------> S0
            C2620 C1720
                 Fa0/0 --> LAN Fa0 --> LAN 2
                           10.10.10.0/24 10.10.11.0/24

I configured NAT on C2620 to:

interface Serial1/0
  ip nat outside
!
inteface Fa0/0
  ip address 10.10.10.1 255.255.255.0
  ip nat inside
!
ip route 0.0.0.0 0.0.0.0 Serial1/0
ip nat inside source list 1 interface Serial1/0 overload
access-list 1 permit 10.10.10.0 0.0.0.255
access-list 1 permit 10.10.11.0 0.0.0.255

Now C1720 is connected to C2620 and computers connected
behind C1720's Fa0 have access to internet via C2620
is necessary to set 'ip nat inside' on interface Serial1/1
on C2620 ?

-- 
TMS

Next message: MPLS Newbie: "[nsp] Can you mix POS,ATM and Ethernet interfaces in a vlan on a catalyst"
Previous message: Badat, Qassim, ALCNS: "[nsp] TACACS"
Maybe in reply to: TMS: "[nsp] "ip nat inside" question"
Next in thread: David Wilde: "Re: [nsp] "ip nat inside" question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:11:58 EDT