Hi,
I'm running a trial using Cisco 7910 connecting to a 2651 in Keyswitch mode to provide the Call Manager functions.
On the Keyswitch router I have configured dial peers to route the call to VOIP gateway connected to the PSTN. When I make a call
from the 7910 and the other end answers the ringing tone continues on the side of the 7910 during the call.
I have tried applying the call progress/connect indicators to the dial peer but the ring continues. The ring also continues if the
other end is engaged or the number etc is incorrect.
Any idea would be appreciated, I have included the config below:
interface FastEthernet0/1
ip address 172.16.24.133 255.255.224.0
duplex auto
speed auto
no cdp enable
h323-gateway voip interface
dial-peer voice 207 voip
description ***LONDON 0207 CALLS WITH 9 TO ACCESS***
destination-pattern 90207.......
progress_ind setup enable 3
session target ipv4:192.168.32.10
keyswitch
load 7910 cmterm-7910
ip source-address 192.168.8.2 port 2000
max-ephones 24
max-dn 48
ephone-dn 1
number 7801
name "GROMMIT"
!
!
ephone 1
mac-address 0007.EB6A.99CC
button 1:1
Regards,
Steve
www.intechnology.co.uk
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:11:59 EDT