I'm looking to be able to set a static route to loopback X as follows:
int loopback 1
ip address 10.1.1.1 255.255.255.255
!
ip route 192.168.1.1 255.255.255.255 loopback 1
and set the reverse dns on 10.1.1.1 to something like
"contact.clipper.net.accounts.dept" or something similar so that on a
traceroute to that ip you see the 10.1.1.1 address showup. The reason I'm
using a loopback is that the particular IP will lose connectivity and call
in... I just get * * * at the router that is dropping the traffic. Any
ideas?
Thanks,
Tim
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
<> Timothy M. Wolfe, Chief Network Engineer <> ClipperNet Corporation/It's a wireless world <>
<> tim@clipper.net 800.338.2629 x 402 <> Sufficient for today=inadequate for tommorow <>
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:06 EDT