Not sure if you can kill an individual process on a Cisco router, unless you
remove that feature and put it back in,
that should do it.
Are you running low on memory ?
I would be more concerned of why are these messages been generated ?
Search CCO for reasons.
Hope this helps.
-----Original Message-----
From: Routing Food [mailto:routing4food@lycos.com]
Sent: Thursday, November 29, 2001 6:23 PM
To: cisco-nsp@puck.nether.net
Subject: [nsp] Kill/Stop/Restart a Router Process?
Hello,
I am getting MALLOCFAIL messages in my log.
It basically references the process = "IP SNMP".
When I do a "show proc mem | inc IP SNMP" I see that
the allocated has 20 billion for this process.
How do I kill this process or restart it?
thanks,
J
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:25 EDT