[nsp] How Keepalive works ? ? ? ? ?

From: Tejal Shah (tejal.shah@surat.iqara.net)
Date: Mon Jan 07 2002 - 01:10:30 EST

Next message: Chris: "[nsp] etherchannel on Cat65"
Previous message: Gert Doering: "Re: [nsp] Cisco 7204 VXR Fast Ethernet lock up after reconfiguration"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Hi all,

I want to implement keep alive on my virtual templante
and enabled vpdn on my ubr7246VXR.

I m confused abt how much packet did my router send to
client and how i configure it for retry for 2 times, if
client didn't respond after 2 retry then that vpdn session
should get disconnect.

Following is the configuration......
=============================================
interface Virtual-Template1
mtu 1492
ip unnumbered Cable3/0.2
ip access-group telnetfilter in
ip mask-reply
ip accounting output-packets
ip accounting access-violations
no ip route-cache
keepalive 600
peer default ip address pool abcd
ppp authentication pap callin one-time

==============================================

Thanks in advance

Tejal
ppp timeout ncp 30
ppp timeout authentication 20

Go To http://www.iqara.net

Next message: Chris: "[nsp] etherchannel on Cat65"
Previous message: Gert Doering: "Re: [nsp] Cisco 7204 VXR Fast Ethernet lock up after reconfiguration"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:28 EDT