This suggestion seemed to work. Thanks.
Scott
-----Original Message-----
From: Jan Gunnik Hope [mailto:Jan.Gunnik.Hope@idcomnet.no]
Sent: Sunday, February 03, 2002 11:37 AM
To: Keoseyan, Scott (Broadwing); cisco-nsp@puck.nether.net
Subject: SV: [nsp] VRF support on a dot1q trunk
Hello !
We've had lots of problems combining VRFs and Dot1Q
subinterfaces.
When we disable route-cache, i.e. :
no ip route-cache
we usually get it working.
Haven't seen exactly the symptoms you see though.
Mostly we see that every second packet is dropped :
"ping" : !.!.!.!.!
Maybe you could try disabling route-cache ?
jgh
---------------------------------------------------------------
Jan Gunnik Hope
CTO, Consultant Team Manager
CCIE # 8221, MCSE
ID Comnet as, www.idcomnet.no
> All this was working fine until I switched out the FDDI for a
fast-ethernet
> dot1q trunk today.
...
> Now, when I take one of the sub-interfaces and its corresponding WAN
> interface out of the VRF, everything goes back to normal.
>
> Any ideas would be helpful...
>
> Scott
>
----------------------------------------------------------------------------
--- This verifies that this e-mail has been scanned for virus and deemed virus-free according to F-secure Content Scanner 5.0 Sun, 3 Feb 2002 17:37:09 +0100 GMT ---------------------------------------------------------------------------- --- +++The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and destroy any copies of this document.+++
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:31 EDT