Re: [nsp] how to select source of ping?

• Next message: KF: "RE: [nsp] Cat 6500... what is really possible together..."
• Previous message: Joel.Andersson@europolitan.se: "SV: [nsp] how to select source of ping?"
• In reply to: Birsen Ozturk: "[nsp] how to select source of ping?"
• Next in thread: Duane de Witt: "RE: [nsp] how to select source of ping?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

On Mon, Feb 11, 2002 at 12:16:53PM +0200, Birsen Ozturk wrote:
> Is it possible to send ping or traceroute from another interface other than the one selected by the routing table?

Yes, if you have enable access to the router.

lhr1a-bdisa-sw1-msfc1#ping
Protocol [ip]:
Target IP address: 10.108.24.74
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]: y
Source address or interface: 10.108.132.2
Type of service [0]:
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.108.24.74, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
lhr1a-bdisa-sw1-msfc1#

-- 
         Ryan O'Connell - CCIE #8174
<ryan@complicity.co.uk> - http://www.complicity.co.uk
I'm not losing my mind, no I'm not changing my lines,
I'm just learning new things with the passage of time

• Next message: KF: "RE: [nsp] Cat 6500... what is really possible together..."
• Previous message: Joel.Andersson@europolitan.se: "SV: [nsp] how to select source of ping?"
• In reply to: Birsen Ozturk: "[nsp] how to select source of ping?"
• Next in thread: Duane de Witt: "RE: [nsp] how to select source of ping?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:32 EDT