i have two subnets 10.10.6.0 and 10.10.3.0 connected on e0 and e1 of a Cisco
2600 respectively. there are no access lists applied on any of them. but i
can't ping between each other. i get request timed out.
any ideas?
Phoram Mehta
Trabon Solutions
Network Engineer
Email:pmehta@trabonsolutions.com <mailto:Email:pmehta@trabonsolutions.com>
Tel: (816) 276 2500 ext: 519
-----Original Message-----
From: Jesper Skriver [mailto:jesper@skriver.dk]
Sent: Friday, February 22, 2002 3:18 PM
To: cisco-nsp@puck.nether.net; Stephen Sprunk; Gyorfy, Shawn
Subject: Re: [nsp] Cisco DS3 Questions..
On Fri, Feb 22, 2002 at 09:16:08PM +0100, Niels Bakker wrote:
> * jesper@skriver.dk (Jesper Skriver) [Fri 22 Feb 2002, 20:53 CET]:
> > We allways use PPP, the primary reasons being:
> >
> > - The line protocol goes down when the line is looped.
>
> Is that dependent on encapsulation used? I don't think so:
>
> !
> interface Serial0
> down-when-looped
> !
>
> is the magic command, if I recall correctly.
Yes, when doing HDLC, PPP will newer come up on a looped line.
And as I said before, it's not default in HDLC, so it's like not to be
configured on a CPE device.
> > - It's easier to debug than HDLC
>
> In what respect? I've had less need for debugging circuits with HDLC
> than with PPP due to authentication templates I talked about before,
> and the physical interface counters are the same.
debug ppp neg
is a lot easier for me to read than
debug serial interface
It could be that I'm more used to it, but all the I've seen you've seen
etc is really annoying, at least I think.
/Jesper
-- Jesper Skriver, jesper(at)skriver(dot)dk - CCIE #5456 Work: Network manager @ AS3292 (Tele Danmark DataNetworks) Private: FreeBSD committer @ AS2109 (A much smaller network ;-)One Unix to rule them all, One Resolver to find them, One IP to bring them all and in the zone to bind them.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:34 EDT