ATM-T1 is for ATM over a IMA circuit (Inverse Multiplexing)
Look for IMA on CCO. Basically IMA allows you to have ATM as
your transport over a DS1 (T1).
BRI - Basic Rate Interface - is used for ISDN 2B1D channels. This is for
q931,q921 signalling. ISDN is digital dialup (basically). The channels are
2*64K (B channels) and 1 16K D channel. The B channels can be setup via your
provider in the following configs:
1B voice
1B voice/data
1B Data
The D channel is often used just for signalling but other uses for this do
exist.
Hope this helps.
DTODD
-----Original Message-----
From: Mehta, Phoram
To: cisco-nsp@puck.nether.net
Sent: 3/8/02 3:55 PM
Subject: [nsp] a Cisco module question!
what is the difference between an Atm-T1 module and a BRI module. can i
use
bri in place ATM-T1?
Phoram Mehta
Trabon Solutions
Network Engineer
Email:pmehta@trabonsolutions.com
<mailto:Email:pmehta@trabonsolutions.com>
Tel: (816) 276 2500 ext: 519
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:35 EDT