[nsp] header compression on FR subinterface

• Next message: Josh Duffek: "Re: [nsp] removing access-list"
• Previous message: Stephen Sprunk: "Re: [nsp] 7206 doesn't understand a blank PS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Can TCP/RTP header compression be enabled on a subinterface in a frame
relay config.

interface Serial1/0.600 point-to-point
 bandwidth 1024
 ip address X.X.X.X 255.255.255.252
 no ip redirects
 no ip directed-broadcast
 no ip proxy-arp
 ip mtu 1500
 frame-relay interface-dlci 600 IETF
 frame-relay ip tcp header-compression
 frame-relay ip rtp header-compression

router#show frame-relay ip rtp header-compression

router#

The circuit runs fine, the CLI accepts everything but no stats are
available. The interface info and the SNMP report no compression related
to the headers. We use to run the same link at a PtP clear channel (non
frame relay) and it all worked. Since moving to the Frame relay config
we can't get the rtp or tcp header compression enabled

Cheers
Thomas

• Next message: Josh Duffek: "Re: [nsp] removing access-list"
• Previous message: Stephen Sprunk: "Re: [nsp] 7206 doesn't understand a blank PS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:36 EDT