Dhiman,
I think the timer command under ospf controls this. The default is 5s after
the route detects a topology change and 10s between SPF calculations. It
builds the LSA at 5s interval and conducts SPF at 10s interval. You could
verify this using ospf debugs.
As a side note, Juniper uses 1s and 5s respectively, but no knobs for the
users to change them.
HTHs
Kent
----- Original Message -----
From: "Dhiman Barman" <dhiman@cs.bu.edu>
To: <cisco-nsp@puck.nether.net>
Sent: Monday, March 25, 2002 12:06 AM
Subject: [nsp] ospf
> Hi,
> How to know the time that router takes to update the ospf routing
> table after any change takes place, say an interface shutdown ?
>
>
> -Dhiman
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:38 EDT