Can you supply the sh commands too please....
> -----Original Message-----
> From: Rakesh [SMTP:rakesh.menon@tataisp.com]
> Sent: Wednesday, April 03, 2002 9:03 AM
> To: Todd, Douglas M.; cisco-nsp@puck.nether.net
> Subject: Re: [nsp] RTO in rotary-group
>
> Pls find the configs
>
> interface BRI0/0
> no ip address
> encapsulation ppp
> dialer rotary-group 0
> isdn switch-type basic-net3
> no cdp enable
> !
> interface BRI0/1
> no ip address
> encapsulation ppp
> dialer rotary-group 0
> isdn switch-type basic-net3
> no cdp enable
> !
> interface Dialer0
> ip address negotiated
> encapsulation ppp
> dialer in-band
> dialer idle-timeout 40000
> dialer string 2387275
> dialer load-threshold 1 either
> dialer-group 1
> ppp authentication pap callin
> ppp pap sent-username ttlblr password 7 111D0D094640090016
> ppp multilink
> ppp timeout multilink link remove 39000
>
> ip route 0.0.0.0 0.0.0.0 Dialer0
>
>
>
>
>
> ----- Original Message -----
> From: "Todd, Douglas M." <DTODD@PARTNERS.ORG>
> To: "'Rakesh'" <rakesh.menon@tataisp.com>; <cisco-nsp@puck.nether.net>
> Sent: Wednesday, April 03, 2002 7:27 PM
> Subject: RE: [nsp] RTO in rotary-group
>
>
> > Can you provide us with a config and some show commands:
> >
> > sh bri int
> > sh ip route
> > sh run
> >
> > ==DMT>
> >
> > > -----Original Message-----
> > > From: Rakesh [SMTP:rakesh.menon@tataisp.com]
> > > Sent: Wednesday, April 03, 2002 7:40 AM
> > > To: cisco-nsp@puck.nether.net
> > > Subject: [nsp] RTO in rotary-group
> > >
> > > Hi ,
> > >
> > > Have created a setup where i have created a dialer interface with 2
> BRI
> > > interfaces in it. This has been done using rotary-group cmd in each
> bri
> > > interface. So both the BRIs dial onto the 3com RAS . But observing
> that
> incase
> > > 1 bri line goes down , getting continuous request time outs even
> though
> the
> > > other line is up and connected . On the line coming up ie back onto 2
> bri
> > > lines(4 channels) , then ping becomes normal after 2-3 min. Ideally
> after some
> > > 2-3 RTO's it should become normal. The default route in that router is
> towards
> > > the dialer. No other route exists. Could anyone help me out why this
> could be
> > > happening.
> > >
> > > Thx&Rgds
> > > Rakesh
> > >
> > >
> > > << File: Rakesh Menon.vcf >>
> >
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:39 EDT