I hope I'm not missing something but I'm having a hard time to get
configs from 12.1 to work with 12.2 releases. I have a frame relay
circuit on which I run LLQ/CBWFQ to make sure the VoIP traffic is out
of the interface 1st (same at the other end).
Sample:
class-map match-all voip
match access-group 100
class-map match-all data1
match access-group 101
!
!
policy-map llq
class voip
priority 256
class data1
bandwidth 128
interface Serial0/0
no ip address
encapsulation frame-relay
no ip mroute-cache
frame-relay traffic-shaping
frame-relay lmi-type ansi
!
interface Serial0/0.102 point-to-point
ip address 192.168.10.2 255.255.255.252
frame-relay interface-dlci 102
frame-relay ip rtp header-compression
map-class frame-relay voice
no frame-relay adaptive-shaping
frame-relay cir 2250000
frame-relay bc 300
frame-relay mincir 2250000
service-policy output llq
access-list 100 permit udp any any range 16384 32000
access-list 100 permit tcp any any eq 1720
access-list 101 permit tcp any any eq www
I can't get my "class voice" statement on the int s0/0.102. Works with
12.1 releases. but not 12.2 (tried on 3620 and 2611)
Has the syntax changed? Did I miss something?
Thomas
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:39 EDT