Re: [nsp] 6500 + MFSC - rate-limiting ?

From: Iva Cabric (ivac@iskon.hr)
Date: Mon Apr 15 2002 - 04:02:02 EDT

Next message: Eric Osborne: "Re: [nsp] Cisco vs. Juniper of LSP setup"
Previous message: Christian Vogel: "[nsp] bridge over framerelay MTU problem."
In reply to: matthew zeier: "[nsp] 6500 + MFSC - rate-limiting ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

On Sun, Apr 14, 2002 at 09:24:17AM -0700, matthew zeier wrote:
>
> I can't found out for certain from CCO if the 6500 + MFSC supports
> rate-limiting per Vlan interface. I'm concerned the "router" isn't seeing
> the full traffic (in the same way the ifInOctets and ifOutOctets don't).
>
> Thanks.

You need Native IOS for this (and supervisor 2 of course), because
traffic never gets to router. Alternative is doing limiting in CatOS.

Next message: Eric Osborne: "Re: [nsp] Cisco vs. Juniper of LSP setup"
Previous message: Christian Vogel: "[nsp] bridge over framerelay MTU problem."
In reply to: matthew zeier: "[nsp] 6500 + MFSC - rate-limiting ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:40 EDT