Re: [nsp] 6500 + MFSC - rate-limiting ?

From: matthew zeier (mrz@intelenet.net)
Date: Mon Apr 15 2002 - 11:44:07 EDT

Next message: Mehta, Phoram: "[nsp] blocking ipx traffic across the network!"
Previous message: Eric Osborne: "Re: [nsp] Cisco vs. Juniper of LSP setup"
In reply to: Iva Cabric: "Re: [nsp] 6500 + MFSC - rate-limiting ?"
Next in thread: matthew zeier: "[nsp] 6500 + MFSC - rate-limiting ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Subject: Re: [nsp] 6500 + MFSC - rate-limiting ?

> On Sun, Apr 14, 2002 at 09:24:17AM -0700, matthew zeier wrote:
> >
> > I can't found out for certain from CCO if the 6500 + MFSC supports
> > rate-limiting per Vlan interface. I'm concerned the "router" isn't
seeing
> > the full traffic (in the same way the ifInOctets and ifOutOctets don't).
> >
> > Thanks.
>
> You need Native IOS for this (and supervisor 2 of course), because
> traffic never gets to router. Alternative is doing limiting in CatOS.

How do I tell if I have Native IOS? And, do you have the syntax for doing
it in CatOS? Thanks.

Next message: Mehta, Phoram: "[nsp] blocking ipx traffic across the network!"
Previous message: Eric Osborne: "Re: [nsp] Cisco vs. Juniper of LSP setup"
In reply to: Iva Cabric: "Re: [nsp] 6500 + MFSC - rate-limiting ?"
Next in thread: matthew zeier: "[nsp] 6500 + MFSC - rate-limiting ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:41 EDT